Change Default Username/Password
It is important that you change the default username and password to something secure. This
new login information ensures that no one within the LAN can make unauthorized changes, but
can also be used as the default remote login information for remote access to the router in the
event changes need to be made remotely by a dealer or a FreedomIQ representative.
Default login information:
Gateway: “10.10.10.1”
Username: “admin”
Password: “password”
Follow these steps to udpate the admin login information:
1. From the “System” section in the left column, select “Passwords”.
2. Scroll to the bottom of the page and select the “Enable” tab.
3. Check “Use password” and enter your new password twice.
4. Click the “Apply” button toward the bottom of the page.
5. Click the “Save” button at the top of the page.
Configuring Internet Access
The AdTran 3120/3130 is easy to set up via the GUI with minimal configuration. Your ISP
should have provided you with general instructions related to your internet connection. If you
are unsure what these settings are, contact your ISP with regard to the settings you will need for
your router. In 99% of all cases your service provider will either have you to set your router to
DHCP mode or they will provide you with IP address, Gateway address, Subnet Mask and DNS
server settings. You will need this information to continue the set up.
Follow these steps to configure internet access:
1. From the “System” section in the left column, select “Public Interface”.
2. Go to “IP Settings” halfway down the page. Your ISP settings will determine whether you
need to choose “Static” or “DHCP” from the drop down. If your ISP has provided you with
a specific IP, select “Static”. If you select “DHCP” skip to step 10. (Screenshot Internet)
3. Enter your IP address in the related field.
4. Enter your subnet mask in the related field.
5. Enter your default gateway in the related field.
6. Click the “Apply” button toward the bottom of the page.
7. Click the “Save” button at the top of the page.
8. From the “System” section in the left column, select “Hostname/DNS”.
9. Enter the primary and secondary DNS addresses provided by ISP. (Screenshot DNS)
10. Click the “Apply” button toward the bottom of the page.
11. Click the “Save” button at the top of the page.
12. Cycle power on the router and give the device 3-5 minutes to boot.
13. Cycle power on any connected devices such as computers, phones etc.
NOTE: See next page for configuration screenshot.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern